Your trusted plumber in Haslemere

Assessment of the boiler and its controls, identification of the fault, repair or replacement of faulty components, testing and safety checks, advice on efficiency and future maintenance.

When you need it. The boiler won't fire up, produces no hot water, makes unusual noises, leaks water, or the pilot light keeps going out.

Before you get in touch. Note down the boiler make and model, when the fault started, and check the pressure gauge reading if visible.

Swift location of the leak source, isolation of the affected pipe or stopcock to stop water flow, temporary or permanent repair of the leak, drying and inspection of affected areas.

When you need it. Water is actively leaking from pipes, joints, radiators or fittings, or water is spreading across ceilings or walls.

Before you get in touch. Turn off the water supply at the stopcock if safe to do so, and turn off the heating if the leak involves radiators or hot pipes.

Inspection of the blockage using drain rods or camera, clearing the obstruction by rodding or jetting, flushing the drain to confirm flow, advice on preventing future blockages.

When you need it. Water drains slowly or backs up, toilets won't flush, or sewage smell is coming from drains or outside gullies.

Before you get in touch. Note which drain is affected, when it started, and whether you've used any drain chemicals recently.

System design and pipe layout planning, installation of boiler and radiators, commissioning and pressure testing, thermostatic control setup, full handover and operating instructions.

When you need it. You need a new heating system, radiators are cold, the system loses pressure regularly, or heating is uneven across the house.

Before you get in touch. Have your property layout ready, note which rooms need radiators, and check your current boiler fuel type if replacing.

Plumbing work for baths, showers, basins and toilets, waste pipe runs and ventilation, water supply connections, testing and final checks, waste removal and site clean.

When you need it. A bathroom needs complete refurbishment, new suites are being installed, or existing fixtures are leaking or obsolete.

Before you get in touch. Have images or sketches of your planned layout, know your water pressure, and check whether you need Building Regulations approval.

Repair or replacement of taps, stopcocks and valves, running new pipe runs, fixing dripping taps, fitting outside taps, updating pipe work where needed, testing connections.

When you need it. Taps drip or leak, you need a new pipe installed, stopcocks are stuck or leaking, or fittings need updating or replacement.

Before you get in touch. Identify which tap or fitting is affected, turn off water supply if it is actively leaking, and note any water discoloration.